Antweight Spinner Electronics

From £10.50

We do not recommend you build a spinner for your first robot as they can be very dangerous. Only test spinning weapons in safe conditions – ideally in a test box. See our disclaimer.


Motor:
A compact brushless motor well suited to adding a spinner to your Antweight with the included M2 screws. Also often used to convert 22mm Motors to brushless drive in Beetleweights. 2mm shaft, output mounting M2 9mm apart. Motor mounting M2 two 12mm and two 16mm apart.

Speed Controller:
A lightweight and compact 12A ESC well suited for spinning the brushless motor.

This setup works with antweight blades from our friends at Monsoon Robotics (look for 9mm bolt hole pattern for M2 bolts)
Typical wiring in an antweight below.

Add Brushless Motor:
Add Brushless Speed Controller:

18 in stock

Categories: , Tags: , , ,
Size

Motor: 23x23x18.5mm
ESC: 50x16x8mm

Weight

Motor: 20.6g including wires
ESC: 7.5g

Input Voltage

Motor: 2-3S Lipo
ESC: 2-4S Lipo

Typical Wiring in an antweight:

Reviews

There are no reviews yet.

Be the first to review “Antweight Spinner Electronics”

Your email address will not be published. Required fields are marked *