Antweight Switch
£0.50
Antweight sized two position SPDT slide switch. Wire inline with the red cable of female JST connector to create a power on/off switch. CAD: step, igs, stl. How to wire the switch below.
93 in stock
Related Products:
-
A5 Polycarbonate Sheets
£2.00-£2.50 Select options -
BBB Edition Antweight Dual ESC v3
£12.50 Add to basket -
BBBxN&B Antweight N10 Gearmotors
£11.00 Select options -
Servo Extender
£4.00 Add to basket -
2S HV High Speed Metal Geared Antweight Servo
£22.50 Add to basket -
MR30 Male Female Pair & Sleeves
£1.00 Add to basket -
XT30 Male Female Pair & Heat Shrink
£1.00 Add to basket -
Flysky 4 Channel Receiver
£11.00-£11.50 Select options
How to wire the switch:
Solder the JST connector red wire to either outer pin on the switch. Solder the your output wire (red wire to what you’re powering for example your speed controller) to the middle pin of the switch. Use heat shrink or electrical tape to cover the pins.
Antweight Drive wiring Diagram:
Components in this example: 2S lipo, JST connector, Switch, BBB Dual ESC, N20 Motors, Flysky Receiver.
Image made by Team DSC.
Reviews
There are no reviews yet.