Antweight N20 Gearmotor with built in ESC


Please read our N20 with Built in ESCs Build Guide for how to use.
N20 30:1 gearmotor with a built in speed controller.

Takes away the need for an external speed controller or soldering – you can plug these directly into the receiver!  Save on weight and wiring from a typical antweight setup.

Comes with:

  • 1 x motor with built in esc
  • 1 x 3 pin cable for motor.

While the manufacturer rates these ESCs for 10V,  we’ve found they’re best paired with a BEC and ran at 5V for longevity.

You’ll need to make sure your receiver supports 2S (up to 8.4V) to connect your lipo directly:If you plan to use your own receiver (not from BBB shop) please ensure it supports at least 8.4V input (a fully charged 2S lipo), or if it doesn’t please connect a BEC between your battery and receiver.

We’d recommend adding a JST input with a switch from the receiver to the battery for safer plugging in and powering on and off.

You’ll need to setup mixing on your transmitter – Mixing Guide

Out of stock

Email when stock available


Motor: 36x12x10mm
ESC: 19.2x11x4.5mm


Motor&ESC: 11g – only ~1.5g more than just the N20!
(14g with included cable – can be shortened to save weight)

Input Voltage

2S lipo

No Load Current

Approximately 40mA at 6V


600rpm @ 6V

Center Braking

None. Motors will not be instantly stopped by zero signal.


There are no reviews yet.

Be the first to review “Antweight N20 Gearmotor with built in ESC”

Your email address will not be published. Required fields are marked *